Precision-turbo-and-engine BigStuff3 GEN3 Engine Torque Management (ETM) Syst Manuale Utente Scaricare il pdf (Pagina 10)

The Initial Calibration (READ BEFORE USING THE SYSTEM):

• Make sure the driveshaft speed sensor is installed and functioning correctly.

• Disable the Torque Management system w/

ETM_Disable. Make sure the box titled “Torque

Control Enable”, in the Torque Parameters table is not checked. See Torque Parameters screen

print above.

• Following the “How to Use the ETM System procedure directly above, collect data from a pass.

• In the Desired_Driveshaft_Table, input desired driveshaft speed values 200 RPM greater than

the actual driveshaft speed data collected in the initial pass.

Interpreting ETM Replay Graphs

Timer enable

“on” starts the

timers.

User inputted

TISS curve

Actual driveshaft

speed or TOSS

value

Rev 1.1

1 2 ... 5 6 7 8 9 10 11 12 13

Nessun commento

Precision-turbo-and-engine BigStuff3 GEN3 Engine Torque Management (ETM) Syst Manuale Utente Pagina 10